How To Repair 140bar/200opsi Pressure Washer Hose

If you own a pressure washer long enough, you are eventually going to experience a leak in the hose.  Sometimes information technology comes from touching the exhaust on a gas-powered washer with the hose.  Other times it's just erstwhile age, or bad luck.

A leak in a pressure washer hose can't be stock-still the manner you lot would fix a garden hose. The patch won't last; the high-force per unit area water will force the patch loose. Even a tiny patched leak can cause serious injury when information technology bursts open, and the loftier-pressure water hits your trunk.   At the very to the lowest degree, you are going to get soaked and whatsoever washing chore you had planned for the day isn't going to get washed.

The layers of wire mesh and plastic distribute the water evenly throughout the hose and contain the force per unit area. To repair the hose, each layer needs to exist shaped and repaired correctly. If not, the repairs won't last.

This isn't the hardest fix, merely information technology's non for everyone.  Sometimes it's best just to replace the hose.

If you adopt repairing the loftier-pressure level hose, here's how.

Steps to Repair Your Power Washer Hose

• Switch off the power of the pressure washer. If you're using an electric pressure level washer, unplug it.
• Press the hose trigger to get rid of any water inside of the hose.
• Find the leak and dry the area effectually the leak.
• Make a square cut on each side of the leak.
• Measure the diameter of the hose.  You lot'll need this to find the correct size pinch plumbing fixtures in the next step.  Nigh residential pressure washers are 0.25″, but check yours to be sure.
• Create a compression seal with a gates compression plumbing equipment. The female repair coupling is contrary threaded and spins counterclockwise when fitted onto the hose. To tighten it apply an adaptable wrench. The male repair coupling fits inside the hose tubing. Use motor oil to lubricate the tip. Place the hose in a vice or use two adaptable wrenches to connect and tighten the two pieces.
• Next, connect the M22 adapter.
• Lastly, spiral the M22 adapter onto the pressure level washer.

Brand sure the gates compression fitting is the right size for the outside and inside of the hose.

Pressure Washer Repair Video Demonstration

If you are the type of person that learns amend from watching rather than reading, the following video does a peachy job of showing only how easy it a fix information technology can be.  I'd recommend checking the price of the gates compression fitting and the M22 adapter first, and comparing that to the price of a new hose before tackling the project.

Source: https://www.backyardworkshop.com/repair-pressure-washer-hose/

Posted by: brunoloicher.blogspot.com

Share this post